H20-651 exam is a required test for HCS-Field-Server certification, which is targeted at leading, installing, operating, maintaining and troubleshooting Huawei server products. If you decide to earn HCS-Field-Server certification, you need to pass H20-651 exam successfully. We provide the latest Huawei certification H20-651-ENU exam dumps, which are valid for you to clear the test easily. H20-651 exam information, outline and exam dumps are important part in your preparation.
Huawei H20-651 Exam
Huawei certification H20-651 exam basic information is helpful for you to understand the test well.
Number of Questions: 60
Exam Fee: 100 USD
Associate Certification: HCS-Field-Server
HCS-Field-Server H20-651 Exam Outline
Huawei HCS-Field-Server H20-651 exam outline cover the following sections.
(1) Server Foundation
(2) Product Knowledge on Huawei Server
(3) Hardware Installation of Huawei Server
(4) Configuration and Operation of Huawei Server
(5) E9000 Blade Server Product Technology
(6) Routine Maintenance and Troubleshooting
Practice Huawei H20-651 Exam Dumps Questions
All the Huawei certification H20-651 exam dumps questions are the best material for you to test the above outline. There are 176 Q&As in Huawei HCS-Field-Server H20-651 exam dumps questions. Share some Huawei Certified Field Specialist-Server H20-651 exam dumps questions and answers below.
1. Server through the network card PXE failed to start, which of the following methods are correct? (Multiple Choice)
A. Verify whether the network card supports PXE
B. Check whether BIOS PXE configuration, network card PXE and NIC UMC function is enabled
C. Check whether the network card fails
D. The service side checks whether the PXE network environment is configured correctly
Answer: ABCD
2. Through the iBMC CLI way to restore the server's BIOS factory settings, what is the command?
A. ipmcset -d clearcmos
B. ipmcset -d resetcmos
C. ipmcset -d intcmos
D. ipmcset -d revovercmos
Answer: A
3. How many ways to configure Meth IP does E9000 server switch board support? (Multiple Choice)
A. Configure via MM910 CLI
B. Configure via MM910 web
C. Configure Through the switchboard serial port
D. Config via sol
Answer: ABCD
4. In IBMC Web page, in which menu to view and set the SNMP information?
A. System settings
B. Alarm settings
C. Network configuration
D. User configuration
Answer: A
5. Which of the following instruction set does the current x86 architecture microprocessor use?
A. Reduced instruction set (RISC)
B. Complex Instruction Set (CISC)
C. Explicit Parallel Instruction Set (EPIC)
D. Serial instruction set
Answer: B